Rate this post by selecting a number. 1 is the worst and 5 is the best.

Author Message   Stan Gray Moderator Username: Stan Post Number: 45 Registered: 01-2007 Rating: N/A Votes: 0 Posted on Wednesday, February 21, 2007 - 11:43 am:    Hey Will, What speeds were you getting before? Is it just missing a few steps or is it going off some where unrelated to the plot? Also did you try setting a ramp? When you get into higher feed speeds you'll need to ramp the start. With Max you have to set true for the ramp in the LPT set up window then set your ramp rate between 1hz to 5hz in the Max port set up. Hope this helps.

Administration Log Out