Rate this post by selecting a number. 1 is the worst and 5 is the best.

Author Message   Tom Aiken New member Username: Tom_aiken Post Number: 7 Registered: 08-2007 Rating: N/A Votes: 0 Posted on Tuesday, August 28, 2007 - 11:45 am:    OK I tried altering the GCode as your message above and still no luck. I tried on 3 different computers the best being a 2.8GHZ P4D Win XP 1Gig Ram. Same results on all... it goes berserk when it encounters multiple motions on one line. The MaxStepper shows ver 4.03 5/29/07 and shows "OK" in the bottom when running KCam. Just to be certain it wasn't a problem with my controller boards or something I rewired the thing for using the parallel port and now everything works fine except I had to set motor speeds slower. At this point it seems like I've narrowed it down to a MaxStepper problem and don't know what to do next. Could it be possible that I have a faulty MaxStepper chip? I have a PIC programmer if you think that may be of some help in diagnosing my problem. Sorry to be such a pain and thanks for all the help so far. Tom

Administration Log Out