| Author | Message | ||
     Fredrik Eriksson New member Username: Fredrik Post Number: 1 Registered: 08-2009 Rating: N/A |
Pleas help. My X axis donīt konow witch way to go But the Z and Y is working perfectly. Al have same setup. I use FET-3. I bought a new board but same problem. New computer same problem. pleas help soon. | ||
| William Iserhardt New member Username: Labrat Post Number: 1 Registered: 02-2009 Rating: N/A |
Check your setup, the fet 3 requires one of the outputs to be reversed | ||
| Fredrik Eriksson New member Username: Fredrik Post Number: 2 Registered: 08-2009 Rating: N/A |
Well it still doesnīt work. tried to revers but then it did not turn at all. | ||
| Kelly Ullrich Moderator Username: Kellyu Post Number: 381 Registered: 02-2007 Rating: N/A |
You could have the step and direction pins mixed up. The x axis driver could be bad. Or you may have a bad parallel port. If you have another PC available, try it's port. Does it work with the manufacturers test software? | ||
| Fredrik Eriksson New member Username: Fredrik Post Number: 3 Registered: 08-2009 Rating: N/A |
I have tried all thinkeble variations with the pins. I use pin 3-2 and 14 for the X-axis. I have also tried to revers the pin 14. I have tried an outher computer. And i have tried an outher FET-3 card. Same resoult - nothing helps. | ||
| Charles Hudman New member Username: Crhudman Post Number: 5 Registered: 08-2008 Rating: N/A |
Have you tried reversing the A or B leads on the Stepper? This is the positive way to change the stepper direction. | ||
| Fredrik Eriksson New member Username: Fredrik Post Number: 4 Registered: 08-2009 Rating: N/A |
Yes I have tried that too. wonder if there is somthing with the compuer settings? | ||
| Kelly Ullrich Moderator Username: Kellyu Post Number: 383 Registered: 02-2007 Rating: N/A |
Does it work with the test software that came with it? | ||
| Fredrik Eriksson New member Username: Fredrik Post Number: 5 Registered: 08-2009 Rating: N/A |
No. Same there. | ||
| Kelly Ullrich Moderator Username: Kellyu Post Number: 384 Registered: 02-2007 Rating: N/A |
If you have tried two boards on two PC's, I would try to find more PC's to check. I think you may have two bad PC's. Use the test software that came with the boards when trying other PC's |
